Ask Mango Bow Tie Man: How Do You Tie an Eldredge Knot?

How Do You Tie an Eldredge Knot?

Its been gaining a lot of popularity through images going viral on sites like Tumblr and Pinterest. And yes, the tie is as tricky to tie as it looks. This might take a heavy dose of patienc because this one might have you working up a sweat.

1. Make sure the wide end of the tie ends at the mid point of your belt because you will tie this entire knot with the little end.

2. While holding the big end in place–create a dimple–swing the little end over the front of the big end and go around the back.

3. Bring the little end up and over the front of the loop.

4. Bring the little end through the loop and towards the right side (make sure the knot is tight).

5. Now bring that little end over the center (of the knot) to the other side and bring it towards the back
again.

6. Bring the little end up over the top of the knot (make sure the knot is tight).

7. Now, this is when it gets a little tricky. Keep this part loose. Create a loose knot by bringing the little end behind and through the loop.

8. Pull the little end through and tighten till you get a tight knot.
It’s halftime baby – almost there. Take a deep breath, a sip of Gatorade and finish strong.

9. Bring the little end behind the loop.

10. Swing it up in front again.

11. And over the top towards the back and to the opposite end.

12. Go through the loop (keep it loose) in a similar fashion to step #7.

13. Pull through and tighten the knot.

14. Hide the remaining little end of the tie behind your loop.

15. Congrats! Now go and impress your friends and coworkers!

I'll put in a link so you can see a video of someone performing this knot:
 Eldredge Knot